Gamma X-Stringer X-ST STRINGING MACHINE (Issue 2 - Octob Manuel d'utilisateur télécharger pdf (Page 9)

8

Pulling Tension

Wrap the loose section of string once around

the roller guide and insert the string between

the diamond dust coated string gripper plates.

Pull the string perpendicular to the gripper

plates while slowly rotating the tensioner

crank clockwise until the brake lever pops

out of the latching block. The string is now

tensioned and can be clamped in place with

the remaining fixed clamp.

Repeat the above steps until all main strings

are installed. Tie off ends of main strings as

per racquet manufacturers recommenda-

tions.

STRINGING THE FRAME

Getting Started

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and pull

excess by hand.

Secure one of the strings using a string

clamp.

Clamping the First Main String

Secure the tensioned main string using the

remaining fixed clamp. Repeat the proce-

dure for all of the remaining main strings and

tie off following the racquet manufacturers

recommendations.

Follow the manufacturer's recommended

stringing pattern for one or two piece string-

ing. This will determine the starting point for

the cross strings. If applicable, tie the first

cross string using an appropriate starting

knot.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

Commentaires sur ces manuels

Pas de commentaire