Gamma X-Stringer X-ST STRINGING MACHINE (Issue 2 - Octob Manuel d'utilisateur télécharger pdf (Page 13)

12

Step 2

Loosen the 1.5 mm locking set screw (A)

located on the side of the latching block as

shown. The set screw is used to hold the

adjustment screw in place.

MAINTENANCE & ADJUSTMENTS

Tension Calibration Procedure

Step 1

Set the tension to 60 lbs. as indicated by the

linear scale and rotary knob. Place the string

on one end of a tension calibrator into a string

clamp and secure. Place string located on

the other end of the calibrator into the string

tensioner and apply tension. If the brake

lever releases before 60 lbs. or after 60 lbs.,

the tension head should be calibrated as

follows.

Step 3

If the lever releases before 60 lbs., using the

supplied L-shaped hex wrench, turn the

adjustment screw (B) located on the left

side of the latch block counter-clockwise to

increase the engagement of the brake re-

lease latch with the brake lever. Repeat step

1 and adjust until the correct tension is

indicated on the calibrator.

If the tension indicated in step 1 is greater

than 60 lbs., turn the adjustment screw

clockwise to reduce the engagement of the

brake release latch with the brake lever.

Repeat step 1 and adjust until the correct

tension is indicated on the calibrator.

B

B

A

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

Commentaires sur ces manuels

Pas de commentaire