Gamma X-Stringer X-6FS STRINGING MACHINE (Issue 1 - May Manuel d'utilisateur télécharger pdf (Page 5)

4

ASSEMBLY INSTRUCTIONS

Installing the Frame Support Posts

Place the support post onto the central slot

of the turntable. While holding the mounting

plate against the inside top surface of the

turntable with your fingers, align the hole in

the support post with the hole in the mounting

plate. Install the mounting bolt through the

support post and into the plate by hand and

tighten with the 6 mm hex wrench. Re-install

the turntable end caps.

Repeat procedure on the opposite side of

the turntable

Remove Mounting Bolts

While holding the mounting plate on the inside

of the turntable remove the support post

mounting bolts.

NOTE: There are two Nylon washers that

are are included for shipping purposes only.

Remove and discard the nylon washers.

Repeat procedure on the opposite side of

the turntable

Support Post Installation

To install the support posts you must first

remove the turntable end cap by grasping

the sides of the end cap and removing it, to

gain access to the inside of the turntable.

Repeat procedure on the opposite side of

the turntable.

If end caps are tight, a flat blade screw driver

may be used to pry the end caps off.

Nylon

washers

1 2 3 4 5 6 7 8 9 10 ... 17 18

Commentaires sur ces manuels

Pas de commentaire