Gamma X-Stringer X-6FC STRINGING MACHINE (Issue 4 - Nove Manuel d'utilisateur télécharger pdf (Page 6)

6

ASSEMBLY INSTRUCTIONS

Installing the Frame Support Posts

Place the support post onto the central slot

of the turntable. While holding the mounting

plate against the inside top surface of the

turntable with your ﬁ ngers, align the hole in

the support post with the hole in the mounting

plate. Install the mounting bolt through the

support post and into the plate by hand and

tighten with the 6 mm hex wrench. Re-install

the turntable end caps.

Repeat procedure on the opposite side of

the turntable

Remove Mounting Bolts

While holding the mounting plate on the

inside of the turntable remove the support

post mounting bolts.

Note: There are two Nylon washers that are

included for shipping purposes only. Remove

and discard the nylon washers.

Repeat procedure on the opposite side of

the turntable

Support Post Installation

To install the support posts you must ﬁ rst

remove the turntable end cap by grasping

the sides of the end cap and removing it, to

gain access to the inside of the turntable.

Repeat procedure on the opposite side of

the turntable.

If end caps are tight, a ﬂ at blade screw driver

may be used to pry the end caps off.

Nylon

Washers

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Commentaires sur ces manuels

Pas de commentaire